Speed ​​and pause tips while you set

As you already know, the function is to set a series of unified efforts. From getting the right attitude to watch properly, put a whole series of methods and flow, and they all have to come together to sink the ball. But there are two tricks in putting things that have virtually nothing to do with the hardware, but they are important to keep your blows down. They are: judging speed and evaluating the break.

Learning how to deal with these two issues is one of the most difficult parts of the golf game to improve and it usually takes a lot of exercises and experiences before you can make significant changes. However, there are a few things you can do to help you improve your consistency with greens and help you sink more putts.

Here are some tips that could help:

Check the grain first: The term "grain" is simply the way the grass grows. This can be determined by searching for & # 39; shine & # 39; or "sheen" of the surface. When the green reflects the sunlight and appears brighter, you look down grain. Sitting grain, or the grain, will usually run faster.

Read the line: When you go green, look general slope of the country A good rule of thumb to remember is that most greens are built higher on the back and lower toward the front. This will definitely affect how to play shots on the green. It's also good to know when you climb green Your approach.

When you put the front of the green (as it slopes down from the back to the front), the putt will turn up. When you're out of your back, the putt will be in a fire.

Now with these minds, someone will putt over this kind of green break usually towards the bottom of the surface, which makes sense only. But knowing this before you can shave a few blows

For the beginning, when you understand contours and grains, you can put them together and think about a powder like this:

Powder that runs with the grain will tend to "run" faster so you need to fix to set "value" accordingly. In other words, you do not have to hit the ball so hard to make it go at the same distance.

When you set a crossroads and your cushions are running with the grain, they will break more and have to be taken into account when you are preparing the shot.

If you put the cross cover against the grain, you must take into account the cushion with a break, and again this must be taken into account before touching the ball with your putter.

If you have to put the grain, hit the ball a bit more difficult than usual. These putts will tend to run slower and without adding value, you must come up short.

When you have to shut down and with the grain, your dumps will not only run faster than they will break more. In this case, beat the ball with less force and let gravity take care of the rest.

The opposite is, of course, true too. If you are up against and against the grain, expect your cushions to keep slower and break less. In this case, put a little extra on the ball to cover it uphill and to overcome the break.

When you judge the break, think about the plumb bob.

The rule of thumb to judge break and size of the offense is to use plumb bobbing. Golfers have used this technology for many years and the reason is that it works!

First, you need to find the dominant eye.

Here you can do it. Make a circle with your thumb and index finger and open your eyes, put an object in the middle – something like a TV, a lamp or a book will do. Finally close the left eye, and then the right eye. Whether the eye holds the object in the middle of circular fingers is your dominant eye.

Now that you know who is your dominant eye, pick up your putter, with a putter hanging freely between your thumb and index finger, behind your ball to match the flag letter. With the prevailing eye you're open, you must notice that the ball is either left, right or right. Directly on means there is no interruption.

If the ball is left, the putt will generally break to the right to the left. And of course, it will break left to right if the ball is on the right. This is not an exact science, but it will help you to give an idea of ​​where the ball will go and you can organize your puzzle accordingly.

If you have this all in mind the next time you install, you should notice adding that you put. But nothing, and I mean nothing, takes a good practice.


Leave a Reply

Your email address will not be published. Required fields are marked *